• Can I cut stainless steel with blades for iron and vice versa?
• How many cuts can I make with a set of blades?
• How many bending programs can I store in the DELEM control?
• Does Vbend import 3D files?
• Is it possible to display the folding sequence generated by vbend on the DA 66W control?

F.A.Q.

Yes, it is possible but we advise you not to do it because the blades would get worn quickly. It is preferable to have a set of blades for stainless steel, even though the percentage of stainless steel plate to be cut is very low.

^ TOP

There is no exact or established number; this value depends on the thcikness of the Sheet to be cut, quality of the Sheet and above all on correct use of the shears. Generally a minimum value of 300 thousand cuts is indicated, up to a maximum of 600 thousand.

^ TOP

DELEM control have 64 Mb of memory (standard), which can also be extended to 128; however, there is no exact number of programs that can be stored, but a maximum number of folds that can be stored in the memory is generally considered. For example a program of 5 folds has a size?� of about 2.5 Kb (numerical program +2D graphics) (from 2.5 to 5 million programs).

^ TOP

NO. For the moment it imports only 2D files. Another software, ACTFOLD (by the ALMA company) must be used which imports 3D files and transforms them directly with the extension *.DLC for Vbend software.

^ TOP

Yes, it is.

^ TOP